Loading ...
Loading ...
Loading ...
EM-32
[VQ35DE]
OIL PAN AND OIL STRAINER
Revision: 2004 November 2004 FX35/FX45
22. Remove transmission joint bolts which pierce oil pan (upper). Refer to AT-266, "TRANSMISSION ASSEM-
BLY" .
23. Remove rear cover plate.
24. Loosen oil pan (upper) bolts with power tool in the reverse order
as shown in the figure to remove.
● Insert seal cutter [SST: KV10111100 (J-37228)] between oil
pan (upper) and cylinder block. Slide seal cutter by tapping on
the side of tool with a hammer. Remove oil pan (upper).
CAUTION:
● Be careful not to damage the mating surface.
● Do not insert a screwdriver, this will damage the mat-
ing surfaces.
25. Remove O-rings from bottom of cylinder block and oil pump.
26. Remove oil pan gaskets.
INSPECTION AFTER REMOVAL
Clean oil strainer if any object attached.
INSTALLATION
1. Install oil pan (upper) as the following:
a. Use scraper to remove old liquid gasket from mating surfaces.
CAUTION:
Do not scratch or damage the mating surfaces when clean-
ing off old liquid gasket.
● Also remove old liquid gasket from mating surface of cylinder
block.
● Remove old liquid gasket from the bolt holes and threads.
PBIC0783E
PBIC1144E
PBIC1145E
MEM108A
Loading ...
Loading ...
Loading ...