Loading ...
Loading ...
Loading ...
EM-190
[VK45DE]
FUEL INJECTOR AND FUEL TUBE
Revision: 2004 November 2004 FX35/FX45
7. Loosen mounting bolts in reverse order as shown in the figure,
and remove fuel tube and fuel injector assembly.
CAUTION:
Do not tilt it, or remaining fuel in pipes may flow out from
pipes.
8. Remove spacers on intake manifold (lower).
9. Remove fuel injector from fuel tube as follows:
a. Open and remove clip.
b. Remove fuel injector from fuel tube by pulling straight.
CAUTION:
● Be careful with remaining fuel that may go out from fuel
tube.
● Be careful not to damage injector nozzles during
removal.
● Do not bump or drop fuel injectors.
● Do not disassemble fuel injectors.
10. Remove fuel damper (RH) and fuel feed damper.
INSTALLATION
1. Install fuel damper (RH) and fuel feed damper.
● When handling O-rings, be careful of the following caution:
CAUTION:
● Handle O-ring with bare hands. Do not wear gloves.
● Lubricate O-ring with new engine oil.
● Do not clean O-ring with solvent.
● Make sure that O-ring and its mating part are free of foreign material.
● When installing O-ring, be careful not to scratch it with tool or fingernails. Also be careful not
to twist or stretch O-ring. If O-ring was stretched while it was being attached, do not insert it
quickly into fuel tube.
● Insert O-ring straight into fuel tube. Do not decenter or twist it.
● Insert fuel damper (RH) and fuel feed damper straight into fuel tube (RH).
● Tighten mounting bolts evenly in turn.
● After tightening mounting bolts, make sure that there is no gap between flange and fuel tube (RH).
2. Install O-rings to fuel injector paying attention to the following caution.
CAUTION:
● Upper and lower O-ring are different. Be careful not to confuse them.
PBIC2338E
PBIC1264E
Loading ...
Loading ...
Loading ...