Loading ...
Loading ...
Loading ...
Open the fuse box cover in the engine compartment ⇒Fuses in the instrument panel and remove
the plastic tweezers.
Depending on the type of fuse, slide the tweezers ⇒Fig.172 ① or ⇒Fig.172 ① onto the
fuse from the side.
Pull out the fuse.
If the fuse is blown, replace the fuse with a new fuse of the same amperage (same color and
same imprint) and same size ⇒ .
Clip the plastic tweezers back into the holder inside the fuse box cover.
Replace the fuse box cover.
NOTE
If a fuse is replaced with a fuse with higher amperage, damage can occur at various places in the
electrical system.
Jump-starting
Introduction to the subject
In this chapter you will find information on the following subjects:
⇒Jump-start terminal
⇒Using jumper cables
If your engine does not start because the vehicle battery is dead, your vehicle's battery can be con‐
nected to the battery of another vehicle to start your engine (jump-starting). Check the battery acid
level indicator on the vehicle battery before jump-starting ⇒Vehicle battery .
You must use jumper cables that meet recognized industrial standards (check information provided by
the jumper cable manufacturer). For vehicles with gasoline engines, the cross-section of the jumper
cable wire must be at least 0.038in. (25mm ), or about 3ga. (AWG).
Location of the vehicle battery
The 12Volt vehicle battery is in the engine compartment.
WARNING
2 2
Loading ...
Loading ...
Loading ...