Loading ...
Loading ...
Loading ...
Note:
3. The logs are classified into eight levels based on severity. The higher the information
severity is, the lower the corresponding level is.
4. This page displays logs in the log buffer, and at most 1024 logs are displayed.
15.2.2 Local Log
Local Log is the log information saved in switch. By default, all system logs are saved in log
buffer and the logs with severities from level_0 to level_2 are saved in log file meanwhile. On
this page, you can set the output channel for logs.
Choose the menu Maintenance→Log→Local Log to load the following page.
Figure 15-4 Local Log
The following entries are displayed on this screen:
Local Log Config
Select
: Select the desired entry to configure the corresponding lo
cal
log.
Channel:
•
Log buffer: Indicates the RAM for saving system log. The
inforamtion in the log buffer is displayed on the Log Table
page. It will be lost when the switch is restarted.
•
Log File: Indicates the flash sector for saving system log.
The inf
ormation in the log file will not be lost after the
switch is restarted and can be exported on the Backup Log
page.
Severity
:
Specify the severity level of the log information output to each
channel. Only the log with the same or smaller severity level
value will be output.
Status:
Enable/Disable the channel.
Sync
-Periodic:
Specify how frequent the log information would be
synchronized to the log file.
15.2.3 Remote Log
Remote log feature enables the switch to send system logs to the Log Server. Log Server is to
centralize the system logs from various devices for the administrator to monitor and manage
the whole network.
223
Loading ...
Loading ...
Loading ...