Loading ...
Loading ...
Loading ...
Items
(CONSULT-II screen terms)
DTC*1 SRT code
Test value/ Test
limit
(GST only)
1st trip DTC*1 Reference page
SFT SOL A/CIRC P0750 — — X AT-172
SFT SOL B/CIRC P0755 — — X AT-177
THERMOSTAT FNCTN P1126 — — X EC-451
SWIRL CONT SOL/V P1130 — — X EC-453
CLOSED LOOP-B1 P1148 — — X EC-476
SWL CON VC SW/CIRC P1165 — — X EC-478
CLOSED LOOP-B2 P1168 — — X EC-476
TCS C/U FUN TN P1211 — — X EC-484
TCS CIRC P1212 — — X EC-486
ENG OVER TEMP P1217 — — X EC-489
IGN SIGNAL-PRIMARY P1320 — — X EC-506
CKP SEN (REF)/CIRC P1335 — — X EC-517
CKP SENSOR (COG) P1336 — — X EC-523
EVAP SMALL LEAK P1440 X X X*2 EC-531
PURG VOLUME CONT/V P1444 — — X EC-533
VENT CONTROL VALVE P1446 — — X EC-545
EVAP PURG FLOW/MON P1447 X X X*2 EC-553
VENT CONTROL VALVE P1448 — — X EC-564
FUEL LEVEL SEN/CIRC P1464 — — X EC-573
VC/V BYPASS/V P1490 — — X EC-576
VC CUT/V BYPASS/V P1491 — — X EC-582
A/T DIAG COMM LINE P1605 — — X EC-594
TP SEN/CIRC A/T P1705 — — X AT-182
P-N POS SW/CIRCUIT P1706 — — X EC-597
O/R CLTCH SOL/CIRC P1760 — — X AT-191
*1: 1st trip DTC No. is the same as DTC No.
*2: These are not displayed with GST.
NOTE:
Regarding A33 models, “-B1” and “BK1” indicate right bank and “-B2” and “BK2” indicate left bank.
HOW TO ERASE EMISSION-RELATED DIAGNOSTIC INFORMATION
NHEC0031S06
How to Erase DTC ( With CONSULT-II)
NHEC0031S0601
NOTE:
If the DTC is not for A/T related items (see EC-8), skip steps 2 through 4.
1. If the ignition switch stays “ON” after repair work, be sure to turn ignition switch “OFF” once. Wait at least
10 seconds and then turn it “ON” (engine stopped) again.
2. Turn CONSULT-II “ON” and touch “A/T”.
3. Touch “SELF-DIAG RESULTS”.
4. Touch “ERASE”. [The DTC in the TCM (Transmission control module) will be erased.] Then touch “BACK”
twice.
5. Touch “ENGINE”.
6. Touch “SELF-DIAG RESULTS”.
ON BOARD DIAGNOSTIC SYSTEM DESCRIPTION
Emission-related Diagnostic Information (Cont’d)
EC-80
Loading ...
Loading ...
Loading ...