Loading ...
Loading ...
Loading ...
13 CHECK (1ST TRIP) DTC
1. Start engine and warm it up to normal operating temperature.
2. Rev (2,000 to 3,000 rpm) two or three times.
3. Make sure no (1st trip) DTC is displayed with CONSULT-II or GST.
OK or NG
OK © GO TO 15.
NG © GO TO 14.
14 REPAIR MALFUNCTION
Repair or replace components as necessary according to corresponding “Diagnostic Procedure”.
© GO TO 13.
15 CHECK TARGET IDLE SPEED
With CONSULT-II
1. Start engine and warm it up to normal operating temperature.
2. Select “ENG SPEED” in “DATA MONITOR” mode with CONSULT-II.
3. Check idle speed.
700±50 rpm (in “P” or “N” position)
Without CONSULT-II
1. Start engine and warm it up to normal operating temperature.
2. Check idle speed.
700±50 rpm (in “P” or “N” position)
OK or NG
OK © GO TO 24.
NG © GO TO 16.
16 PERFORM IDLE AIR VOLUME LEARNING
Refer to “Idle Air Volume Learning”, EC-66.
Which is the result CMPLT or INCMP?
CMPLT or INCMP
CMPLT © GO TO 17.
INCMP © 1. Follow the construction of “Idle Air Volume Leaning”.
2. GO TO 16.
17 CHECK TARGET IDLE SPEED AGAIN
With CONSULT-II
1. Start engine and warm it up to normal operating temperature.
2. Select “ENG SPEED” in “DATA MONITOR” mode with CONSULT-II.
3. Check idle speed.
700±50 rpm (in “P” or “N” position)
Without CONSULT-II
1. Start engine and warm it up to normal operating temperature.
2. Check idle speed.
700±50 rpm (in “P” or “N” position)
OK or NG
OK © GO TO 22.
NG © GO TO 18.
GI
MA
EM
LC
FE
AT
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
TROUBLE DIAGNOSIS — BASIC INSPECTION
Basic Inspection (Cont’d)
EC-117
Loading ...
Loading ...
Loading ...