Loading ...
Loading ...
Loading ...
4 CHECK IGNITION TIMING AND ENGINE IDLE SPEED
Check the following items. Refer to “Basic Inspection”, EC-109.
MTBL0616
Models with CONSULT-II © GO TO 5.
Models without CON-
SULT-II
© GO TO 6.
5 CHECK THROTTLE POSITION SWITCH
With CONSULT-II
1. Start engine and warm it up to normal operating temperature.
2. Turn ignition switch “OFF”.
3. Turn ignition switch “ON”.
4. Select “DATA MONITOR” mode with CONSULT-II.
5. Check indication of “CLSD THL/P SW” under the following conditions.
Measurement must be made with throttle position switch installed in vehicle.
MTBL0355
OK or NG
OK © GO TO 8.
NG © GO TO 7.
6 CHECK THROTTLE POSITION SWITCH
Without CONSULT-II
1. Start engine and warm it up to normal operating temperature.
2. Turn ignition switch “OFF”.
3. Disconnect closed throttle position switch harness connector.
4. Check continuity between closed throttle position switch terminals 4 and 5 under the following conditions.
Resistance measurement must be made with throttle position switch installed in vehicle.
SEC010C
OK or NG
OK © GO TO 9.
NG © GO TO 7.
GI
MA
EM
LC
FE
AT
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
DTC P0510 CLOSED THROTTLE POSITION SWITCH
Diagnostic Procedure (Cont’d)
EC-443
Loading ...
Loading ...
Loading ...