Loading ...
Loading ...
Loading ...
TEST ITEM CONDITION JUDGEMENT CHECK ITEM (REMEDY)
PURG VOL
CONT/V
I Engine: After warming up, run
engine at 1,500 rpm.
I Change the EVAP canister purge
volume control solenoid valve
opening percent using CON-
SULT-II.
Engine speed changes according
to the opening percent.
I Harness and connector
I Solenoid valve
VENT
CONTROL/V
I Ignition switch: ON
(Engine stopped)
I Turn solenoid valve “ON” and
“OFF” with the CONSULT-II and
listen to operating sound.
Solenoid valve makes an operating
sound.
I Harness and connector
I Solenoid valve
VC/V BYPASS/V
I Ignition switch: ON
(Engine stopped)
I Turn solenoid valve “ON” and
“OFF” with the CONSULT-II and
listen to operating sound.
Solenoid valve makes an operating
sound.
I Harness and connector
I Solenoid valve
SWIRL CONT
SOL VALVE
I Ignition switch: ON
I Turn solenoid valve “ON” and
“OFF” with CONSULT-II and lis-
ten for operating sound.
Solenoid valve makes an operating
sound.
I Harness and connector
I Solenoid valve
VIAS SOL VALVE
I Ignition switch: ON
I Turn solenoid valve “ON” and
“OFF” with CONSULT-II and lis-
ten for operating sound.
Solenoid valve makes an operating
sound.
I Harness and connector
I Solenoid valve
ENGINE MOUNT-
ING
I Engine: After warming up, run
engine at idle speed.
I Gear position: “D”’ range
(Vehicle stopped)
I Turn electronic controlled engine
mount “IDLE” and “RAVEL” with
the CONSULT-II.
Body vibration changes according
to the electronic controlled engine
mount condition.
I Harness and connector
I Electronic controlled engine
mount
DTC & SRT CONFIRMATION MODE
NHEC0034S08
SRT STATUS Mode
NHEC0034S0801
For details, refer to “SYSTEM READINESS TEST (SRT) CODE”,
EC-70.
SRT Work Support Mode
NHEC0034S0803
This mode enables a technician to drive a vehicle to set the SRT
while monitoring the SRT status.
ON BOARD DIAGNOSTIC SYSTEM DESCRIPTION
CONSULT-II (Cont’d)
EC-100
Loading ...
Loading ...
Loading ...