Loading ...
Loading ...
Loading ...
SEF212Y
SEF213Y
WITH CONSULT-II
NHEC0371S01
1) Turn ignition switch “ON”.
2) Select “P/N POSI SW” in “DATA MONITOR” mode with CON-
SULT-II. Then check the “P/N POSI SW” signal under the fol-
lowing conditions.
Position (Selector lever) Known-good signal
“N” and “P” position ON
Except the above position OFF
If NG, go to “Diagnostic Procedure”, EC-600.
If OK, go to following step.
3) Select “DATA MONITOR” mode with CONSULT-II.
4) Start engine and warm it up to normal operating temperature.
5) Maintain the following conditions for at least 60 consecutive
seconds.
ENG SPEED 1,800 - 2,600 rpm
COOLAN TEMP/S More than 70°C (158°F)
B/FUEL SCHDL 2 - 10 msec
VHCL SPEED SE 70 - 100 km/h (43 - 62 MPH)
Selector lever Suitable position
6) If 1st trip DTC is detected, go to “Diagnostic Procedure”,
EC-600.
SEF359X
Overall Function Check
NHEC0372
Use this procedure to check the overall function of the park/neutral
position (PNP) switch circuit. During this check, a 1st trip DTC
might not be confirmed.
WITH GST
NHEC0372S01
1) Turn ignition switch “ON”.
2) Check voltage between ECM terminal 44 and body ground
under the following conditions.
Condition (Gear position) Voltage V (Known good data)
“P” and “N” position Approx. 0
Except the above position Battery voltage
3) If NG, go to “Diagnostic Procedure”, EC-600.
DTC P1706 PARK/NEUTRAL POSITION (PNP) SWITCH
DTC Confirmation Procedure (Cont’d)
EC-598
Loading ...
Loading ...
Loading ...