Loading ...
Loading ...
Loading ...
Diagnostic Procedure
NHEC0603
1 CHECK THE OVERALL FUNCTION
With CONSULT-II
1. After warming up engine, run it at idle speed.
2. Shift selector lever to “D” range while depressing the brake pedal and pulling the parking brake control lever.
3. Perform “ENGINE MOUNTING” in “ACTIVE TEST” mode with CONSULT-II and check that the body vibration changes
according to switching the condition (With vehicle stopped).
SEF074Y
Without CONSULT-II
1. After warming up engine, run it at idle speed.
2. Shift selector lever to “D” range while depressing the brake pedal and pulling the parking brake control lever.
3. Disconnect front or rear electronic controlled engine mount harness connector when engine speed is more than 1,000
rpm.
Radiator cap
Front electronic controlled
engine mount harness connector
Battery
Rear electronic controlled
engine mount harness connector
View with intake air duct removed
SEF285XA
4. When returning engine speed to idle speed, check that the body vibration increases, compared with the condition of the
above step 2 (With vehicle stopped).
OK or NG
OK © INSPECTION END
NG © GO TO 2.
ELECTRONIC CONTROLLED ENGINE MOUNT
Diagnostic Procedure
EC-626
Loading ...
Loading ...
Loading ...