Loading ...
Loading ...
Loading ...
PROCEDURE FOR MALFUNCTION A
NHEC0078S01
CAUTION:
Always drive vehicle at a safe speed.
TESTING CONDITION:
I Before performing the following procedure, confirm that
battery voltage is more than 10V at idle.
I This test may be conducted with the drive wheels lifted in
the shop or by driving the vehicle. If a road test is
expected to be easier, it is unnecessary to lift the vehicle.
SEF065Y
With CONSULT-II
NHEC0078S0101
1) Turn ignition switch “ON” and select “DATA MONITOR” mode
with CONSULT-II.
2) Start engine and maintain the following conditions for at least
5 consecutive seconds.
Vehicle speed More than 4 km/h (2 MPH)
Selector lever Suitable position except “P” or “N” position
3) If 1st trip DTC is detected, go to “Diagnostic Procedure”,
EC-182.
With GST
NHEC0078S0102
Follow the procedure “With CONSULT-II” above.
SEF058Y
PROCEDURE FOR MALFUNCTION B
NHEC0078S02
With CONSULT-II
NHEC0078S0201
1) Turn ignition switch “ON”.
2) Select “DATA MONITOR” mode with CONSULT-II.
3) Start engine and let it idle for at least 10 seconds.
If idle speed is over 1,000 rpm, maintain the following condi-
tions for at least 10 seconds to keep engine speed below 1,000
rpm.
Selector lever Suitable position except “P” or “N”
Brake pedal Depressed
Vehicle speed 0 km/h (0 MPH)
4) If 1st trip DTC is detected, go to “Diagnostic Procedure”,
EC-182.
With GST
NHEC0078S0202
Follow the procedure “With CONSULT-II” above.
DTC P0120 THROTTLE POSITION SENSOR
DTC Confirmation Procedure (Cont’d)
EC-178
Loading ...
Loading ...
Loading ...