Loading ...
Loading ...
Loading ...
SEF205Y
SEF206Y
SEF237Y
WITH CONSULT-II
NHEC0323S01
1) Start engine and warm it up to normal operating temperature.
2) Turn ignition switch “OFF” and wait at least 10 seconds.
3) Turn ignition switch “ON”.
4) Select “PURG VOL CN/V P1444” of “EVAPORATIVE SYS-
TEM” in “DTC WORK SUPPORT” mode with CONSULT-II.
5) Touch “START”.
6) Start engine and let it idle until “TESTING” on CONSULT-II
changes to “COMPLETED”. (It will take for approximately 10
seconds.)
If “TESTING” is not displayed after 5 minutes, retry from
step 2.
7) Make sure that “OK” is displayed after touching “SELF-DIAG
RESULTS”. If “NG” is displayed, refer to “Diagnostic
Procedure”, EC-537.
WITH GST
NHEC0323S02
1) Start engine and warm it up to normal operating temperature.
2) Turn ignition switch “OFF” and wait at least 10 seconds.
3) Start engine and let it idle for at least 20 seconds.
4) Select “MODE 7” with GST.
5) If 1st trip DTC is detected, go to “Diagnostic Procedure”,
EC-537.
GI
MA
EM
LC
FE
AT
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
DTC P1444 EVAP CANISTER PURGE VOLUME CONTROL SOLENOID VALVE
DTC Confirmation Procedure (Cont’d)
EC-535
Loading ...
Loading ...
Loading ...