Loading ...
Loading ...
Loading ...
7 CHECK CMPS (PHASE) SHIELD CIRCUIT FOR OPEN AND SHORT
1. Turn ignition switch “OFF”.
2. Disconnect joint connector-18.
3. Check the following.
I Continuity between joint connector terminal 1 and ground
I Joint connector
(Refer to EL-525, “HARNESS LAYOUT”.)
Continuity should exist.
4. Also check harness for short to power.
5. Then reconnect joint connector-18.
OK or NG
OK © GO TO 8.
NG © Repair open circuit or short to power in harness or connectors.
8 CHECK INTERMITTENT INCIDENT
Refer to “TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT”, EC-144.
© INSPECTION END
DTC P0340 CAMSHAFT POSITION SENSOR (CMPS) (PHASE)
Diagnostic Procedure (Cont’d)
EC-356
Loading ...
Loading ...
Loading ...