Loading ...
Loading ...
Loading ...
3 CHECK ACCELERATOR WIRE INSTALLATION
Check accelerator wire for slack.
OK or NG
OK © GO TO 4.
NG © Adjust accelerator wire. Refer to FE-3, “Adjusting Accelerator Wire”.
4 CHECK THROTTLE VALVE OPERATION
1. Remove intake air ducts.
2. Check throttle valve operation when moving throttle drum by hand.
OK or NG
OK © Retighten the throttle drum fixing nuts.
NG © Clean the throttle body and throttle valve.
5 CHECK THROTTLE POSITION SWITCH CLOSED POSITION
With CONSULT-II
1. Turn ignition switch “ON”.
2. Select ”CLSD THL/P SW” in “DATA MONITOR” mode with CONSULT-II.
3. Read “CLSD THL/P SW” signal under the following conditions.
I Insert a 0.05 mm (0.0020 in) and 0.15 mm (0.0059 in) feeler gauge alternately between stopper and throttle drum as
shown in the figure and check the signal.
SEC017C
SEF173Y
“CLSD THL/P SW” signal should remain “ON” while inserting 0.05 mm (0.0020 in) feeler gauge.
“CLSD THL/P SW” signal should remain “OFF” while inserting 0.15 mm (0.0059 in) feeler gauge.
OK or NG
OK © GO TO 8.
NG © GO TO 6.
TROUBLE DIAGNOSIS — BASIC INSPECTION
Basic Inspection (Cont’d)
EC-110
Loading ...
Loading ...
Loading ...