Loading ...
Loading ...
Loading ...
15 CHECK THROTTLE POSITION SWITCH
With CONSULT-II
1. Install all removed parts.
2. Start engine and warm it up to normal operating temperature.
3. Turn ignition switch “OFF”.
4. Turn ignition switch “ON”.
5. Select “DATA MONITOR” mode with CONSULT-II.
6. Check indication of “CLSD THL/P SW” under the following conditions.
Measurement must be made with throttle position switch installed in vehicle.
MTBL0355
OK or NG
OK © GO TO 18.
NG © GO TO 17.
16 CHECK THROTTLE POSITION SWITCH
1. Install all removed parts.
2. Start engine and warm it up to normal operating temperature.
3. Turn ignition switch “OFF”.
4. Disconnect closed throttle position switch harness connector.
5. Check continuity between closed throttle position switch terminals 4 and 5 under the following conditions.
Resistance measurement must be made with throttle position switch installed in vehicle.
SEC010C
OK or NG
OK © GO TO 18.
NG © GO TO 17.
DTC P1447 EVAPORATIVE EMISSION (EVAP) CONTROL SYSTEM PURGE
FLOW MONITORING
Diagnostic Procedure (Cont’d)
EC-562
Loading ...
Loading ...
Loading ...