Loading ...
Loading ...
Loading ...
SEF058Y
DTC Confirmation Procedure
NHEC0166
NOTE:
If “DTC Confirmation Procedure” has been previously conducted,
always turn ignition switch “OFF” and wait at least 10 seconds
before conducting the next test.
TESTING CONDITION:
Before performing the following procedure, confirm that bat-
tery voltage is between 10.5V and 16V at idle.
WITH CONSULT-II
NHEC0166S01
1) Turn ignition switch “ON” and select “DATA MONITOR” mode
with CONSULT-II.
2) Start engine.
3) Drive vehicle at a speed of more than 70 km/h (43 MPH) for 2
consecutive minutes.
4) Stop vehicle and let engine idle for at least 6 seconds.
5) If 1st trip DTC is detected, go to “Diagnostic Procedure”,
EC-289.
WITH GST
NHEC0166S02
1) Start engine.
2) Drive vehicle at a speed of more than 70 km/h (43 MPH) for 2
consecutive minutes.
3) Stop vehicle and let engine idle for at least 6 seconds.
4) Turn ignition switch “OFF” and wait at least 10 seconds.
5) Start engine.
6) Drive vehicle at a speed of more than 70 km/h (43 MPH) for 2
consecutive minutes.
7) Stop vehicle and let engine idle for at least 6 seconds.
8) Select “MODE 3” with GST.
9) If DTC is detected, go to “Diagnostic Procedure”, EC-289.
I When using GST, “DTC Confirmation Procedure” should
be performed twice as much as when using CONSULT-II
because GST cannot display MODE 7 (1st trip DTC) con-
cerning this diagnosis. Therefore, using CONSULT-II is
recommended.
DTC P0141 (BANK 1), P0161 (BANK 2) HO2S2 HEATER (REAR)
DTC Confirmation Procedure
EC-286
Loading ...
Loading ...
Loading ...