Loading ...
Loading ...
Loading ...
24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Configure Switching User Manual133
Possible field values are as follows:
• Auto. All supported speeds. This is the default setting.
•
10Mbps. 10 Mbits/second.
• 100Mbps. 100 Mbits/second.
• 1000Mbps. 1000 Mbits/second.
The delimiter characters for setting different speed values are a comma (,), a period (.)
and
a
space ( ). For you to set the autonegotiation speed, the autonegotiation mode must
be set to Enable. The default is Auto.
Note: After you
change the speed value, the switch might be inaccessible for
a number of seconds while the new settings take effect.
14. From the Duplex
Mode menu, select the duplex mode for the selected port.
Possible values are as follows:
• Auto. Indicates that speed is set by the auto-negotiation process.
• Full. Indicates that the interface supports transmission between the devices in both
directions simultaneously
.
•
Half. Indicates that the interface supports transmission between the devices in only
one direction at a time.
The default is Auto.
Note: After you
change the duplex mode, the switch might be inaccessible for
a number of seconds while the new settings take effect.
15. From the Auto Power Down Mode menu, select whether the auto power down mode of the
Green Ethernet
feature is enabled or disabled.
The default is disabled.
16. Use the Link
Trap menu to select whether to send a trap when link status changes.
The default is enabled for normal interfaces and disabled for LAG interfaces.
17. From the Flow
Control menu, select to enable or disable IEEE 802.3 flow control.
The default is disabled. The switch does not send pause frames if the port buffers
become full. Flow control helps to prevent data loss when the p
ort cannot keep up with
the number of frames being switched. When flow control is enabled, the switch can send
a pause frame to stop traffic on a port if the amount of memory used by the packets on
the port exceeds a preconfigured threshold and responds to pause requests from partner
devices. The paused port does not forward packets for the period of time specified in the
pause frame. When the pause frame time elapses, or the utilization returns to a specified
low threshold, the switch enables the port to again transmit frames. For LAG interfaces,
flow control mode is displayed as a blank field because flow control is not applicable.
18. Click
the Apply
button.
Your settings are saved.
Loading ...
Loading ...
Loading ...