Loading ...
Loading ...
Loading ...
ERROR MESSAGES
405
10
Appendix
If the machine is not properly set and the “Start/Stop” button or the “Reverse/Reinforcement Stitch” button
is pressed, or if the operation procedure is incorrect, the machine does not start. An alarm sounds and an
error message is displayed on the LCD. If an error message displays, follow the instructions in the
message.
Below is an explanation of error messages. Refer to these when necessary (if you press or do the
operation correctly while the error message is displayed, the message disappears).
ERROR MESSAGES
CAUTION
• Be sure to rethread the machine. If you press the “Start/Stop” button without rethreading the machine,
the thread tension may be wrong or the needle may break and cause injury.
This message is displayed
when the motor locks due
to tangled thread or for
other reasons related to
thread delivery.
This message is displayed
when the embroidery unit is
initializing.
This message is displayed
when you try to sew with a
stitch other than a middle
needle position stitch while
the single-hole needle plate
is installed.
This message is displayed
when the needle plate is
removed with the machine
on or when the machine is
turned on and embroidery
or embroidery edit mode is
selected (see page 59).
This message is displayed
when the machine needs to
be maintained. (see page
390)
This message is displayed
when the needle plate
cover is not attached.
This message is displayed
when you try to combine
more than 71 patterns.
This message is displayed
when the buttonhole lever
is up, a buttonhole stitch is
selected, and the “Start/
Stop” button or “Reverse/
Reinforcement Stitch”
button is pushed.
This message is displayed
when the speed control
lever is set to control the
zigzag stitch width, and the
“Start/ Stop” button is
pushed. Use the foot
controller to operate the
machine.
This message appears
when there are not enough
colors in the custom thread
table, to display the color
scheme you have selected
to display.
In this case, set more
colors in the custom thread
table (See page 237), or
select less colors in the
color shuffling function.
(See page 241.)
Loading ...
Loading ...
Loading ...