Loading ...
Loading ...
Loading ...
INSPECTION PROCEDURE
=NFEC0028S02
1 INSPECTION START
1. Check service records for any recent repairs that may indicate a related problem, or a current need for scheduled
maintenance.
2. Open engine hood and check the following:
– Harness connectors for improper connections
– Wiring harness for improper connections, pinches and cut
– Vacuum hoses for splits, kinks and improper connections
– Hoses and ducts for leaks
– Air cleaner clogging
– Gasket
SEF983U
3. Confirm that electrical or mechanical loads are not applied.
– Headlamp switch is OFF.
– Air conditioner switch is OFF.
– Rear window defogger switch is OFF.
– Steering wheel is in the straight-ahead position, etc.
4. Start engine and warm it up until engine coolant temperature indicator points the middle of gauge.
Ensure engine stays below 1,000 rpm.
SEF976U
5. Run engine at about 2,000 rpm for about 2 minutes under no-load.
SEF977U
6. Make sure that no DTC is displayed with CONSULT-II or GST.
OK or NG
OK © GO TO 3.
NG © GO TO 2.
2 REPAIR OR REPLACE
Repair or replace components as necessary according to corresponding “Diagnostic Procedure”.
© GO TO 3.
BASIC SERVICE PROCEDURE
Idle Speed/Ignition Timing/Idle Mixture Ratio Adjustment (Cont’d)
EC-62
Loading ...
Loading ...
Loading ...