Loading ...
Loading ...
Loading ...
13 CHECK EVAP CANISTER VENT CONTROL VALVE-II
With CONSULT-II
1. Reconnect harness connectors disconnected.
2. Turn ignition switch “ON”.
3. Perform “VENT CONTROL/V” in “ACTIVE TEST” mode.
4. Check air passage continuity and operation delay time.
SEC158D
Without CONSULT-II
Check air passage continuity and operation delay time under the following conditions.
SEF378Z
Make sure new O-ring is installed properly.
OK or NG
OK © GO TO 15.
NG © GO TO 14.
14 CHECK EVAP CANISTER VENT CONTROL VALVE-III
1. Clean the air passage (Portion A to B) of EVAP canister vent control valve using an air blower.
2. Perform Test No. 13 again.
OK or NG
OK © GO TO 15.
NG © Replace EVAP canister vent control valve.
15 CHECK EVAP PURGE LINE
Inspect EVAP purge line (pipe and rubber tube). Check for evidence of leaks.
Refer to “EVAPORATIVE EMISSION LINE DRAWING”, EC-40.
OK or NG
OK © GO TO 16.
NG © Replace it.
GI
MA
EM
LC
FE
CL
MT
AT
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
DTC P0441 EVAP CONTROL SYSTEM
Diagnostic Procedure (Cont’d)
EC-359
Loading ...
Loading ...
Loading ...