Loading ...
Loading ...
Loading ...
SEF058Y
PROCEDURE FOR MALFUNCTION C
With CONSULT-II
1) Turn ignition switch “ON” and wait at least 1 second.
2) Select “DATA MONITOR” mode with CONSULT-II.
3) Shift selector lever to “D” position and wait at least 2 seconds.
4) Shift selector lever to “N” or “P” position.
5) Start engine and let it idle for 3 seconds.
6) If DTC is detected, go to “Diagnostic Procedure”, EC-472.
With GST
Follow the procedure “WITH CONSULT-II” above.
Diagnostic Procedure
NFEC1413
1 CHECK ELECTRIC THROTTLE CONTROL ACTUATOR VISUALLY
1. Remove the intake air duct.
2. Check if a foreign matter is caught between the throttle valve and the housing.
SEC083D
OK or NG
OK © GO TO 2.
NG © Remove the foreign matter and clean the electric throttle control actuator inside.
2 REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
1. Replace the electric throttle control actuator.
2. Perform “Throttle Valve Closed Position Learning”, EC-71.
3. Perform “Idle Air Volume Learning”, EC-71.
© INSPECTION END
DTC P1121 ELECTRIC THROTTLE CONTROL ACTUATOR
DTC Confirmation Procedure (Cont’d)
EC-472
Loading ...
Loading ...
Loading ...