Loading ...
Loading ...
Loading ...
2 CHECK APP SENSOR 1 POWER SUPPLY CIRCUIT
1. Disconnect accelerator pedal position (APP) sensor harness connector.
2. Turn ignition switch “ON”.
SEC081D
3. Check voltage between APP sensor terminals 6 and ground with CONSULT-II or tester.
SEC093D
Voltage: Approximately 5V
OK or NG
OK © GO TO 4.
NG © GO TO 3.
3 DETECT MALFUNCTIONING PART
Check the following.
I Harness connectors M161, F68
I Harness for open or short between ECM and accelerator pedal position sensor
© Repair open circuit or short to ground or short to power in harness or connectors.
4 CHECK APP SENSOR 1 GROUND CIRCUIT FOR OPEN AND SHORT
1. Turn ignition switch “OFF”.
2. Check harness continuity between APP sensor terminal 3 and engine ground.
Refer to Wiring Diagram.
Continuity should exist.
3. Also check harness for short to ground and short to power.
OK or NG
OK © GO TO 6.
NG © GO TO 5.
5 DETECT MALFUNCTIONING PART
Check the following.
I Harness connectors M161, F68
I Harness for open or short between ECM and accelerator pedal position sensor
© Repair open circuit or short to ground or short to power in harness or connectors.
GI
MA
EM
LC
FE
CL
MT
AT
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
DTC P0227, P0228 APP SENSOR
Diagnostic Procedure (Cont’d)
EC-315
Loading ...
Loading ...
Loading ...