Loading ...
Loading ...
Loading ...
SERVICING AND MAINTENANCE 485
Front/Rear Axle Fluid
For normal service, periodic fluid level checks are not
required. When the vehicle is serviced for other reasons the
exterior surfaces of the axle assembly should be inspected. If
gear oil leakage is suspected inspect the fluid level. Refer to
“Fluids And Lubricants” in “Technical Specifications” for
further information.
Fluid Level Check
Lubricant should be approximately 1/8 inch (3 mm) below
the bot
tom edge of the oil fill hole.
NOTE:
Make sure that the vehicle is level and supported by the axles
Adding Fluid
Add lubricant only at the fill hole and only to the level spec-
ified above.
Selection Of Lubricant
Use only the manufacturer's recommended fluid. Refer to
“
Fluids
And Lubricants” in “Technical Specifications” for
further information.
Transfer Case
Selection Of Lubricant
Use only the manufacturer's recommended fluid. Refer to
“Fluids
And Lubricants” in “Technical Specifications” for
further information.
• Do not allow petroleum based fluid to contaminate the
brake
fluid. Brake seal components could be damaged,
causing partial or complete brake failure. This could
result in a collision.
WARNING! (Continued)
7
Loading ...
Loading ...
Loading ...