Loading ...
Loading ...
Loading ...
172 GETTING TO KNOW YOUR VEHICLE
HomeLink Buttons/Overhead Console
NOTE:
HomeLink is disabled when the Vehicle Security Alarm is
a
c
tive.
Before You Begin Programming HomeLink
Be sure that your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmission
of the r
adio-frequency signal it is recommended that a new
battery be placed in the hand-held transmitter of the device
that is being programmed to the HomeLink system.
To erase the channels, place the ignition in the ON/RUN
position
, and push and hold the two outside HomeLink
buttons (I and III) for up to 20 seconds or until the orange
indicator flashes.
NOTE:
• E
rasing all channels should only be performed when
programm
ing HomeLink for the first time. Do not erase
channels when programming additional buttons.
• If you have any problems, or require assistance, please call
toll-fr
ee 1-800-355-3515 or, on the Internet at HomeLink.com
for information or assistance.
Programming A Rolling Code
For programming garage door openers that were manufac-
tured after 1995. These garage door openers can be identified
by the “L
EARN” or “TRAIN” button located where the
hanging antenna is attached to the garage door opener.
NOTE:
It is NOT the button that is normally used to open and close
the door
. The name and color of the button may vary by
manufacturer.
Loading ...
Loading ...
Loading ...