Loading ...
Loading ...
Loading ...
176 GETTING TO KNOW YOUR VEHICLE
3. Continue to press and hold the HomeLink button, while
you press and release (“cycle”) your hand-held trans-
mitter every two seconds until HomeLink has success-
fully accepted the frequency signal. The indicator light
wi
ll fla
sh slowly and then rapidly when fully trained.
4. Watch for the HomeLink indicator to change flash
rates.
When it changes, it is programmed. It may take
up to 30 seconds or longer in rare cases. The garage
door may open and close while you are programming.
5. Press and hold the programmed HomeLink button and
observ
e the indicator light.
NOTE:
• If the indicator light stays on constantly, programming is
comple
te and the garage door/device should activate
when the HomeLink button is pressed.
• To program the two remaining HomeLink buttons, repeat
each s
tep for each remaining button. DO NOT erase the
channels.
If you unplugged the garage door opener/device for
programm
ing, plug it back in at this time.
Reprogramming A Single HomeLink Button (Canadian/
Gate Op
erator)
To reprogram a channel that has been previously trained,
follow t
hese steps:
1. Cycle the ignition to the ON/RUN position.
2. Pres
s and hold the desired HomeLink button until the
indica
tor light begins to flash after 20 seconds. Do not
release the button.
3. Without releasing the button, proceed with “Canadian/
Gate O
perator Programming” step 2 and follow all
remaining steps.
Using HomeLink
To operate, push and release the programmed HomeLink
button. Activation will now occur for the programmed
device (i.e. garage door opener, gate operator, security
system, entry door lock, home/office lighting, etc.). The
hand-held transmitter of the device may also be used at any
time.
Loading ...
Loading ...
Loading ...