Loading ...
Loading ...
Loading ...
104 GETTING TO KNOW YOUR VEHICLE
Rear Hard Top Installation
NOTE:
If the door frames are installed from soft top usage, they
must be
removed prior to installation of the hard top. Refer
to “Door Frame” in this section for installation procedures.
1. Inspect the hard top seals for damage and replace if
necess
ary.
2. Install the hard top using the same steps for removal in
revers
e order.
Make sure that the hard top is sitting flush with the body
at the
sides and check to ensure that there is a uniform
gap between the lift glass and hard top.
NOTE:
The Torx fasteners that attach the hard top to the body
should
be torqued as follows using the provided #50 Torx
head dr
iver and ratchet:
• Hard top to B-pillar: 119 in-lb
+/- 23 in-lb (13.5 N·m +/
- 2.7 N·m)
• Hard top to J-rail: 154 in-lb
+/- 30 in-lb (17.5 N·m +/-
3.5 N·m)
DOOR FRAME
WARNING!
• Do not drive your vehicle on public roads with the door
frame(
s) removed as you will lose the protection that
they can provide. This procedure is furnished for use
during off-road operation only.
• Do not drive your vehicle on public roads with the
doors re
moved as you will lose the protection that they
can provide. This procedure is furnished for use during
off-road operation only.
CAUTION!
• O
pening a door or lowering a window while the top is
wet ma
y allow water to drip into the vehicle's interior.
• Careless handling and storage of the removable door
frame(
s) may damage the seals, causing water to leak
into the vehicle's interior.
• The door frame(s) must be positioned properly to
ensure
sealing. Improper installation can cause water to
leak into the vehicle's interior.
Loading ...
Loading ...
Loading ...