Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR INSTRUMENT PANEL 203
What to do when an electrical load reduction action
message is present (“Battery Saver On” or “Battery Saver
Mode”)
During a trip:
• Reduce power to unnecessary loads if possible:
• Turn of
f redundant lights (interior or exterior)
• Check wh
at may be plugged in to power outlets +12V,
150W, U
SB ports
• Check HVAC settings (blower, temperature)
• Check t
he audio settings (volume)
After a
trip:
• Check if any aftermarket equipment was installed (addi-
tional
lights, upfitter electrical accessories, audio systems,
alarms)
and review specifications if any (load and Ignition
Off Draw currents).
• Evaluate the latest driving cycles (distance, driving time
and par
king time).
• The vehicle should have service performed if the message
is stil
l present during consecutive trips and the evaluation
of the vehicle and driving pattern did not help to identify
the cause.
WARNING LIGHTS AND MESSAGES
The warning/indicator lights will illuminate in the instru-
ment panel together with a dedicated message and/or
acoustic
signal when applicable. These indications are indic-
ative and precautionary and as such must not be considered
a
s exhau
stive and/or alternative to the information
contained in the Owner’s Manual, which you are advised to
read carefully in all cases. Always refer to the information in
this chapter in the event of a failure indication. All active tell
-
tales will display first if applicable. The system check menu
may appea
r different based upon equipment options and
current vehicle status. Some telltales are optional and may
not appear.
Red Warning Lights
— Air Bag Warning Light
This warning light will illuminate to indicate a fault with the
air bag,
and will turn on for four to eight seconds as a bulb
check when the ignition is placed in the ON/RUN or ACC/
ON/RUN position. This light will illuminate with a single
chime when a fault with the air bag has been detected, it will
stay on until the fault is cleared. If the light is either not on
during startup, stays on, or turns on while driving, have the
system inspected at an authorized dealer as soon as possible.
3
Loading ...
Loading ...
Loading ...