Loading ...
Loading ...
Loading ...
174 GETTING TO KNOW YOUR VEHICLE
NOTE:
If the garage door opener/device does not activate, push the
button
a third time (for two seconds) to complete the
training.
To program the remaining two HomeLink buttons, repeat
each st
ep for each remaining button. DO NOT erase the
channels.
Reprogramming A Single HomeLink Button (Rolling
Code)
To r
eprogram a channel that has been previously trained,
follow t
hese steps:
1. Cycle the ignition to the ON/RUN position.
2. Push
and hold the desired HomeLink button until the
indica
tor light begins to flash after 20 seconds. Do not
release the button.
3. Without releasing the button proceed with “Program-
ming A
Rolling Code” step 2 and follow all remaining
steps."
P
rogramming A Non-Rolling Code
For programming Garage Door Openers manufactured
before
1995.
1. C
ycle the ignition to the ON/RUN position.
2
. Plac
e the hand-held transmitter 1 to 3 inche
s (3 to 8 cm)
away from the HomeLink button you wish to program
while keeping the HomeLink indicator light in view.
3. Press and hold the HomeLink button you want to
program
while you press and hold the hand-held trans-
mitter button.
4. C
ontinue to hold both buttons and observe the indicator
light.
The HomeLink indicator will flash slowly and then
rapidly after HomeLink has received the frequency signal
from the hand-held transmitter. Release both buttons
after the indicator light changes from slow to rapid.
Loading ...
Loading ...
Loading ...