Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 175
5. Press and hold the programmed HomeLink button and
observe the indicator light.
• If the indicator light stays on constantly, programming
is com
plete and the garage door/device should acti-
vate when the HomeLink button is pressed.
• T
o program the two remaining HomeLink buttons,
repeat
each step for each remaining button. DO NOT
erase the channels.
Reprogramming A Single HomeLink Button (Non-Rolling
Code)
To r
eprogram a channel that has been previously trained,
follow t
hese steps:
1. Cycle the ignition to the ON/RUN position.
2. Pres
s and hold the desired HomeLink button until the
indica
tor light begins to flash after 20 seconds. Do not
release the button.
3. Without releasing the button, proceed with “Program-
ming A
Non-Rolling Code” step 2 and follow all
remaini
ng steps.
Canadian/Gate Operator Programming
For programming transmitters in Canada/United States that
require the transmitter signals to “time-out” after several
seconds of transmission.
Canadian radio frequency laws require transmitter signals to
time-ou
t (or quit) after several seconds of transmission –
which may not be long enough for HomeLink to pick up the
signal during programming. Similar to this Canadian law,
some U.S. gate operators are designed to time-out in the
same manner.
It may be helpful to unplug the device during the cycling
process
to prevent possible overheating of the garage door or
gate motor.
1. Cycle the ignition to the ON/RUN position.
2. Plac
e the hand-held transmitter 1 to 3 inche
s (3 to 8 cm)
away from the HomeLink button you wish to program
while keeping the HomeLink indicator light in view.
2
Loading ...
Loading ...
Loading ...