Loading ...
Loading ...
Loading ...
440 IN CASE OF EMERGENCY
Road Tire Installation
1. Mount the road tire on the axle.
2. Install the remaining lug nuts with the cone shaped end
of the
nut toward the wheel. Lightly tighten the lug nuts.
3. Lower the vehicle to the ground by turning the jack
handle
counterclockwise.
4. Finish tightening the lug nuts. Push down on the wrench
while
at the end of the handle for increased leverage.
Tighten the lug nuts in a star pattern until each nut has been
tightened twice. For the correct lug nut torque refer to
“Torque Specifications” in “Technical Specifications”. If in
doubt about the correct tightness, have them checked with
a torque wrench by an authorized dealer or service station.
5. After 25 miles
(40 km), check the lug nut torque with a
torque wrench to ensure that all lug nuts are properly
seated against the wheel.
MANUAL PARK RELEASE
To push or tow the vehicle in cases where the transmission
will not shift out of PARK (such as a dead battery), a Manual
Park Release is available.
Follow these steps to use the Manual Park Release:
1. Firmly apply the parking brake.
2. Remo
ve the manual park release cover, located above the
gear se
lector, to access the release tether strap.
WARNING!
To avoid the risk of forcing the vehicle off the jack, do
not tight
en the wheel nuts fully until the vehicle has
been lowered. Failure to follow this warning may result
in serious injury.
WARNING!
Always secure your vehicle by fully applying the
parking
brake before activating the Manual Park
Release. In addition, you should be seated in the driver’s
seat with your foot firmly on the brake pedal when
activating the Manual Park Release. Activating the
Manual Park Release will allow your vehicle to roll away
if it is not secured by the parking brake, or by proper
connection to a tow vehicle. Activating the Manual Park
Release on an unsecured vehicle could lead to serious
injury or death for those in or around the vehicle.
Loading ...
Loading ...
Loading ...