Loading ...
Loading ...
Loading ...
Connecting
Connect the terminal and then the terminal.
After switching on the ignition, the warning lights
are lit up.
.
If, after a short distance, one of the above-men-
tioned indicator lights does not go out, seek the
help of a specialist garage.
Commission these functions after disconnecting
and connecting the vehicle battery
Clock setting » page 49.
Window operation » page 24.
Sunblind » page 25.
Changing
The new vehicle battery must have the same param-
eters as the original battery. Have the replacement
carried out by a specialist garage.
Using the jump-starting cable
What you should be mindful of
WARNING
Risk of explosion and chemical burns!
Do not jump start with the battery of another vehi-
cle under the following conditions.
The discharged vehicle battery is frozen. A dis-
charged vehicle battery can freeze at tempera-
tures just below 0°C.
The battery acid level is too low » page 140.
Use jump leads with a sucient cross section and in-
sulated terminal clamps.
The rated voltage of both batteries must be 12V. The
capacity (in Ah) of the charging battery must not be
significantly lower than the capacity of the dis-
charged battery.
Jump-starting with the battery of another
vehicle
WARNING
Risk of injury and danger of vehicle damage!
Lay the jump start cables so that they cannot be-
come caught by rotating parts in the engine com-
partment.
NOTICE
Short circuit!
The non-insulated parts of the terminal clamps
must not touch each other.
The cable connected to the positive pole of the
battery must not come into contact with electri-
cally conductive vehicle parts.
The vehicles must not touch each other.
Start the engine
Connect the terminal clamps of the jump start ca-
bles in the order shown in the legend.
1
pole of the flat battery.
2
pole of the current-giving battery.
3
pole of the current-giving battery.
4
Earth point of the engine to be started.
Start the engine of the
current-giving vehicle
and let it idle.
Start the engine of the
vehicle with the flat
battery.
If the engine of the ve-
hicle with the dis-
charged battery does
not start within 10 sec-
onds, repeat the start-
ing procedure after ap-
proximately 30 seconds.
Disconnecting the cable
Disconnect the cables in the reverse order from
connection.
Fuses
What you should be mindful of
NOTICE
Fire hazard and risk of damage to the electrical sys-
tem.
Do not repair fuses or replace them with stronger
fuses.
Replace the defective fuse with a new fuse with
the same amperage.
We recommend using replacement fuses from the
ŠKODA Genuine Accessories range. These guaran-
tee reliable and safe consumer protection.
If a newly inserted fuse blows again, seek the help
of a specialist garage.
One fuse may belong to several consumers. One
consumer may have several fuses.
Earth point
141
Vehicle battery and fuses › Using the jump-starting cable
Loading ...
Loading ...
Loading ...