Loading ...
Loading ...
Loading ...
Troubleshooting
Coolant level is too low
or illuminates
Message concerning the required coolant
check
›
Check the coolant level.
The coolant level is OK:
›
Check the fuse for radiator fan, replace if re-
quired » page 142, Replacing a fuse.
The fuse is OK, the indicator light comes on again:
›
Stop driving! Seek the help of a specialist garage.
Coolant temperature too high
or
illuminates
Report regarding the engine overheating
›
Stop driving.
›
Stop the engine and allow it to cool.
›
Drive on after the indicator light goes out.
Engine fault
or lights up.
›
Stop driving!
›
Stop the engine and seek the help of a specialist
garage.
There is no coolant of the correct specification
available
›
Top up with distilled or demineralised water.
›
Have the correct coolant mixing ratio corrected by
a specialist garage as soon as possible.
Another substance was used for topping up, other
than distilled or demineralised water:
›
Have the coolant changed by a specialist garage.
It is not possible to top up with a sucient amount
of coolant
›
Stop driving.
›
Stop the engine and seek the help of a specialist
garage.
There is a loss of coolant
›
Top up the coolant and seek the help of a specialist
garage.
Engine electronics
Troubleshooting
Petrol engine control faulty
illuminates
Driving in emergency mode is possible - a
noticeable reduction in engine performance may oc-
cur.
›
Continue driving, exercising appropriate caution,
and seek the help of a specialist garage.
Diesel engine control faulty
flashing
Driving in emergency mode is possible - a noticeable
reduction in engine performance may occur.
›
Continue driving, exercising appropriate caution,
and seek the help of a specialist garage.
Diesel preheating system faulty
illuminates, or does not illuminate after the
ignition is switched on
Driving in emergency mode is possible - a noticeable
reduction in engine performance may occur.
›
Continue driving, exercising appropriate caution,
and seek the help of a specialist garage.
Particle filter
Troubleshooting
Clogged particle filter
or
illuminates
›
Clean the filter.
When the indicator light is on, it must be as-
sumed that fuel consumption will be higher, engine
power will be reduced, and the START-STOP func-
tion will not be available.
Filter cleaning
Conditions for cleaning
✓ The engine is warm.
Procedure for vehicles with diesel engines
›
Drive at a speed of at least 60 km/h at engine
speeds of at least 2000 rpm.
If the filter is successfully cleaned, the indicator light
goes o.
If the indicator light does not go o within 40
minutes, no filter cleaning was performed.
›
Continue driving, exercising appropriate caution,
and seek the help of a specialist garage.
Procedure for vehicles with petrol engines
›
Drive at a speed of at least 80 km/h at engine
speeds between 3000-5000 rpm.
›
Release the accelerator pedal and let the vehicle
roll with the gear engaged for a few seconds.
›
Repeat this procedure several times.
If the filter is successfully cleaned, the indicator light
goes o.
135
Engine, exhaust system and fuel › Engine electronics
Loading ...
Loading ...
Loading ...