Loading ...
Loading ...
Loading ...
20
IMPORTANT:
You must program each unit ID using the main keypad first before attempting remote access.
EACH unit in the Chain must have the same "Rings Before Unit Answers" 16.
Factory Setting - 5 Rings
EACH unit in the Chain must have the same "Alternate Prefix" 115.
Factory Setting - Normal (use
to enter programming)
Make sure the “Rings Before Unit Answers” value 16 is greater than “Maximum Rings Allowed Before Aborting
Attempt” value 14.
Up to seven (7) units can be installed on a single telephone line. Each unit must have a "Unique Unit ID" number and
the "Number of Units in Chain" assigned to it.
Set the Unit ID Number and Number of Units in Chain: 2
The unit ID identifies each unit within a chain. Adding or removing will require the unit ID’s to be re-entered.
Factory Setting: Unit ID 1 and Number of Units in Chain 1.
1
Press Then
2
Unit ID Number (1-7), Then
3
Total Number of Units in Chain (1-7), Then
Unique Unit ID Sequencial Order
Number of
Units in Chain “7”
Residence
Unit ID “7”Unit ID “3”Unit ID “2”Unit ID “1”
Telco Entrance Box
Demarcation Point
EXAMPLE:
IMPORTANT: This must be performed
for EACH unit in the Chain.
Verify Unit Number: 111
This allows you to verify a unit’s number within a chain. When you perform this step, the unit will respond with
the number corresponding to its unit ID number. The message two (2), for example, means the unit is number
2 in the chain.
Then
If you make an error during an entry, press the asterisk key (*) to begin again.
PROGRAMMING MULTIPLE UNITS OVERVIEW
Loading ...
Loading ...
Loading ...