Loading ...
Loading ...
Loading ...
44
clients.
End IP Enter the starting IP address of the pool. Only IP
address within the start/end range will be assigned to
clients.
Subnet mask Enter a valid subnet mask.
Gateway Enter a valid gateway address.
Primary Enter a primary DNS server address.
Secondary Enter a secondary DNS server address.
14. Choose to enable or disable VLAN.
15. If VLAN is enabled, specify the following information:
Note: If VLAN and NAT mode are both enabled, the devices IP connection setting must
be configured to use the same VLAN in order to connect to the Internet. Refer to the
Editing a Device section on page 64.
VLAN mode Select the VLAN type.
Tagged: Adds an 802.1Q header to traffic.
Untagged: Does not add a tag to traffic.
VLAN tag If the VLAN mode is set to Tagged, specify a VLAN
tag. This will segment traffic with the respective VLAN
tag.
16. Choose to enable or disable Station Isolation. This prevents clients connected to the
same SSID from communicating with each other.
17. Choose to enable URL redirection.
18. If URL redirection is enabled, specify the following information:
URL for redirection Enter the URL clients connecting to the SSID will be
redirected to.
Redirection interval Enter the time (in minutes) clients will be periodically
redirected to the URL.
19. Click Save.
20. Click Push Configuration.
8.1.5.3 Configuring Basic SSID Settings
Loading ...
Loading ...
Loading ...