Loading ...
Loading ...
Loading ...
Using Field Sensor Data
6
113
EN
Recording and Saving Logs
While the LOG switch is in the LOG position, the camera will log GPS and other
sensor data (P. 111). Logs can be downloaded for use with the OLYMPUS Image
Track (OI.Track) smartphone app.
Rotate the LOG switch to LOG.
• Logging will start. The indicator lamp will blink while
logging is in progress.
• Logging ends automatically when the battery runs low (P. 134).
• In LOG mode, the camera draws on the battery continuously to acquire location data.
• No data can be added to the log once the memory allocated to temporary log storage is
full, in which case you will need to rotate the LOG switch to OFF to save the log to the
card (P. 134).
Saving logs
The current log is saved to the card when the LOG switch is rotated to
OFF.
• A message is displayed in the monitor while the log is being saved. Do not remove the
card until the message has cleared from the display. Removing the card while the log is
being saved could cause loss of the log fi le or camera or card malfunction.
• The camera may not begin saving the log to the card when the LOG switch is rotated
to OFF if, for example, wireless data transfer is in progress or the card is full or write-
protected, in which case you should terminate wireless data transfer, delete unwanted
data from the card, or otherwise enable the log to be saved. Do not remove the battery
from the camera until the log has been saved.
• The log will not be saved if no card is inserted.
• Logs will not be saved if the battery is low. Charge the battery.
• Each card can store up to 199 log fi les. An error message will be displayed when the log
fi le count approaches this number (P. 134). Should this occur, insert another card or
delete log fi les after copying them to a computer.
• Log fi les are recorded to the “GPSLOG” and “SNSLOG” folders on the card (P. 15).
Loading ...
Loading ...
Loading ...