Loading ...
Loading ...
Loading ...
Part Number STH14 9/10 99
If brix adjustments are needed you will have to remove
the merchandiser to make the mechanical
adjustments. Please see PROGRAM MODE 2 in this
section for internal brixing instructions using the
control board and the Brixing Procedure for detailed
instructions on brixing the FRP-250.
CRUSHED OR CUBED DEFAULT
This selectable ice option will allow the unit to always
default to either cube or crushed ice or remain at the
last selection. This only applies to control boards
020000875 Rev 7 and up.
How to set default ice dispense setting
CUBE DEFAULT
1. Power on the unit by plugging in receptacle and
holding the cube button at the same time, cube
will flash 2 times. Unit will now change to cube 10
seconds after crush is selected.
CRUSH DEFAULT
2. Power on the unit by plugging in receptacle and
holding the crushed button at the same time,
crush will flash 2 times. Unit will now change to
crush 10 seconds after cube is selected.
LAST SELECTION DEFAULT
3. Power on the unit by plugging in receptacle and
holdding cube and crush at the same time, cube
and crush will flash 2 times. Unit will now remain
in selection of last request.
NOTE: If power is lost to the unit and then powered up
again the unit will retain the last setting and not return
to factory settings.
STH14.book Page 99 Thursday, September 23, 2010 3:35 PM
Loading ...
Loading ...
Loading ...