Loading ...
Loading ...
Loading ...
Part Number STH14 9/10 103
PROGRAM MODE 2
Brixing
Mode 2 displayed above, puts your Flav'R-Pic into brix
mode. In this setting when a corresponding touch pad
is pressed, water or syrup will be dispensed for a fixed
duration in order to set your ratios using a standard
brix cup and making adjustments to the mechanical
valves. Follow the steps below to put a board into brix
mode.
1. Choose a control board. If brixing drinks for N1
(Nozzle 1) or N3 use the left control board, if
brixing drinks for N3 or N6 use the right control
board. Beverage dispense points are designated
by a black nozzle.
2. Press the program button and hold for 3 seconds
or until the LED displays 1. Press the program
button again until 2 is displayed on the control
board LED display.
NOTE: Programming one board at a time will make it
easier for you to identify the corresponding valves and
dispense points.
3. With the a board in Mode 2, you can now brix any
water or syrup valve that corresponds to the
board. Use the illustration in Installation/Brixing or
the Control board, Valve, Touch Pad Matrix to
identify the valves and which board they
correspond to. Brixing information can also be
found on the unit, on the right hand side of the
control board cover label. By using this label in
combination with the plumbing label located on
the foam front you will be able to identify each
valve, water, and/or syrup combination.
4. Replace the nozzle when done then move on to
another nozzle or, if you are finished brixing,
return the control board to the dispense mode by
pressing the program button and holding for 3
seconds or until the LED displays 0.
A brixing break down for each nozzle is available in
the Brixing Procedure section of this manual.
STH14.book Page 103 Thursday, September 23, 2010 3:35 PM
Loading ...
Loading ...
Loading ...