Loading ...
Loading ...
Loading ...
Part Number STH14 9/10 105
S12 = Chaser left to right
S11 = Chaser right to left
S10 = Off all
S9 = Flash outside to center, Flavor Shot Off
5. When done move on to another programming
mode or, if you are finished, return the control
board to the dispense mode by pressing the
program button and holding for 3 seconds or until
the LED displays 0.
CONTROL BOARD TIME OUT
Flav’R-Pic (FRP-250) Brixing Procedure
NOTE: This procedure is for flavors requiring 5:1 water
to syrup ratio.
Control Board Label
Important
When installed on a FRP without flavor shots the
lighting sequence S8 & S9 should be used. All
other units are set to S1 & S16 by default.
Important
If a control board is left in any program mode for
longer than 5 minutes it will automatically time out
and return to dispense mode 0. In order to enter
back into a program mode you will need to press
the program button and hold for 3 seconds or
until the LED displays 1 again.
Brixing
Info
Left Side
Program
Button
Right Side
Program
Button
STH14.book Page 105 Thursday, September 23, 2010 3:35 PM
Loading ...
Loading ...
Loading ...