Loading ...
Loading ...
Loading ...
Part Number STH14 9/10 107
4. Locate the control board that corresponds with
the valve(s) and/or dispense point you want to
brix.
5. Press the program button and hold for 3 seconds
or until the LED displays 1. Press the program
button again until 2 is displayed on the control
board LED display.
NOTE: Programming one board at a time will make it
easier for you to identify the corresponding valves and
dispense points. See Flav’R-Pic External
Programming in this manual for more detail on all
programming modes.
6. With a board in Mode 2 you can now brix any
water or syrup valve that corresponds to the
board. Use the chart above to identify the valves
and which board they correspond to. See the
illustration that follows for more assistance.
Brixing information can also be found on the right
hand side of the control board cover label. By
using this label in combination with the plumbing
label you will be able to identify each valve, water,
and/or syrup combination.
Left Board Right Board
Dispense Type and
Valve Number
C1 - Valve 8 C3 - Valve 4
C2 - Valve 11 C4 - Valve 1
NC2 - Valve 11 NC3 - Valve 4
S1 - Valve 8 S9 - Valve 15
S2 - Valve 9 S10 - Valve 3
S3 - Valve 9 S11 - Valve 3
S4 - Valve 14 S12 - Valve 7
S5 - Valve 14 S13 - Valve 7
S6 - Valve 10 S14 - Valve 2
S7 - Valve 10 S15 - Valve 2
S8 - Valve 15 S16 - Valve 1
F1 - Valve 13 F5 - Valve 6
F2 - Valve 13 F6 - Valve 6
F3 - Valve 12 F7 - Valve 5
F4 - Valve 12 F8 - Valve 5
C = Carb NC = Non-Carb S = Syrup F = Flavor Shot
STH14.book Page 107 Thursday, September 23, 2010 3:35 PM
Loading ...
Loading ...
Loading ...