Loading ...
Loading ...
Loading ...
98 Part Number STH14 9/10
FRP-250 with out Flavor Shots
NOTE: The buttons for FRP units without flavor shots are
located in the same area, but are hidden.
3. You can now stop pressing on the F1 or F5 button and
the 4 LEDs around the touch pad area should now be
illuminated. If not illuminated you did not successfully
go into external brix mode and need to try again, or the
FRP unit is not equipped with this program mode.
In this setting when a corresponding touch pad is pressed
water or syrup will be dispensed for a fixed duration in order
to check your ratios using a standard brix cup.
4. In this mode you can now check the brix for any water
or syrup valve that corresponds to the board. Use the
illustration in Installation/Brixing or the Control board,
Valve, Touch Pad Matrix to identify the valves and
which board they correspond to. Brixing information
can also be found on the unit, on the right hand side of
the control board cover label. By using this label in
combination with the plumbing label located on the
foam front you will be able to identify each valve, water,
and/or syrup combination.
5. When finished checking the brix return the unit to
dispense mode by turning the keyswitch to the "OFF"
position, waiting till the touch pad LEDs are not
illuminated, then turn the keyswitch back to the "ON"
position.
Important
If left in external brix mode for longer than 5
minutes it will automatically time out and return to
dispense mode.
S1
S3
S2
S4
S5
S7
S6
S8
F1
F2
F4
F3
N1
N3
S12
S10
S11
S9
S16 S14
S15
S13
F5
F6
F8
F7
N4
N6
Right
Hidden
Touchpad
Button
Left
Hidden
Touchpad
Button
Left Carb/
Non-Carb
Right
Carb/Non-
Carb
STH14.book Page 98 Thursday, September 23, 2010 3:35 PM
Loading ...
Loading ...
Loading ...