Loading ...
Loading ...
Loading ...
Part Number STH14 9/10 115
6. Check each syrup position and adjust syrup on
the corresponding valve as necessary. A
plumbing label is located on the foam front of the
unit showing the position of each valve and syrup
port. See the plumbing diagram.
7. Move to another nozzle or, if you are finished
brixing, return the control board to the dispense
mode by pressing the program button and holding
for 3 seconds or until the LED displays 0. Replace
the splash panel and merchandiser.
FlexTower Programming Modes
CONTROL BOARD RUN OR DISPENSE MODE
(Control Board LED Displays 0)
For finished drink, press and hold any labeled finished
drink touchpad area to manually dispense a finished
noncarbonated drink (all touchpad areas are defaulted
from factor to manual dispense mode). For flavor
adder, press any labeled flavor adder touchpad area
and a one shot stored timed dispense will occur
(dispense time of flavor adder can be changed in
program mode 2).
Program
Button
LED
Display
STH14.book Page 115 Thursday, September 23, 2010 3:35 PM
Loading ...
Loading ...
Loading ...