Loading ...
Loading ...
Loading ...
41
5.4.4 Region Intrusion
Region Intrusion: Alarms will be triggered if the target intrudes into the pre-defined areas.
This function can be applicable to important supervision places, danger areas and
prohibited areas, like military administrative zones, high danger areas, no man’s areas, etc.
Go to Config→Event→Region Intrusion interface as shown below.
1. Enable intrusion detection and select the snapshot type and the detection target.
Save Original Picture to SD Card: If it is enabled, the detected original pictures will be
captured and saved to the SD card when the targets intrude into the pre-defined areas.
Save Target Picture to SD Card: If it is enabled, the detected target cutout pictures will be
captured and saved to the SD card when the targets intrude into the pre-defined areas.
Note: To save snapshots to the local PC, please enable “Local Smart Snapshot Storage” in
the local config interface first. To save snapshots to the SD card, please install an SD card
first.
Detection Target:
Human: Select it and then alarms will be triggered if someone intrudes into the pre-defined
area.
Motor Vehicle: Select it and then alarms will be triggered if a vehicle with four or more
wheels (eg. a car, bus or truck) intrudes into the pre-defined area.
Non-motor Vehicle: Select it and then alarms will be triggered if a vehicle with two wheels
(eg. a motorcycle or bicycle) intrudes into the pre-defined area.
All of the three types of objects can be selected simultaneously. Please select the detection
objects as needed. If no object/target is selected, alarms will not be triggered even if
intrusion detection is enabled.
2. Set the alarm holding time.
3. Set alarm trigger options. The setup steps are the same as motion detection. Please
Loading ...
Loading ...
Loading ...