Loading ...
Loading ...
Loading ...
29
5.3 Alarm Configuration
5.3.1 Motion Detection
Go to Alarm→Motion Detection to set motion detection alarm.
1. Check “Enable” check box to activate motion-based alarms. If unchecked, the camera
will not send out any signals to trigger motion-based recording to the NVR or CMS,
even if there is motion in the video.
Alarm Holding Time: it refers to the interval time between the adjacent motion detections.
For instance, if the alarm holding time is set to 20 seconds, once the camera detects a
motion, it will go to alarm and would not detect any other motion in 20 seconds. If there is
another motion detected during this period, it will be considered as continuous movement;
otherwise, it will be considered as a single motion.
Alarm Out: If selected, this would trigger external relay outputs that are connected to the
camera on detecting a motion-based alarm.
Trigger SD Card Snapshot: If selected, the system will capture images on motion
detection and save the images on an SD card.
Trigger SD Card Recording: If selected, video will be recorded on an SD card on motion
detection.
Trigger Email: If “Trigger Email” and “Attach Picture” are checked (email address must be
set first in the Email configuration interface), the captured pictures and triggered event will
be sent into those addresses.
Trigger FTP: If “Trigger FTP” and “Attach Picture” are checked, the captured pictures will
be sent into FTP server address. Please refer to 5.5.10 FTP configuration chapter for more
details.
2. Set motion detection area and sensitivity. Click the “Area and Sensitivity” tab to go to
the interface as shown below.
Loading ...
Loading ...
Loading ...