Loading ...
Loading ...
Loading ...
Cleaning and care
100
The amount of solution specified can be
more than the amount which is actually
taken in. Some of the solution may
therefore be left in the container at the
end of descaling.
A message will appear to confirm that
the intake process is completed.
Confirm with OK.
The activation phase will begin. You
can follow the time counting down in
the display.
Leave the container with the tube
connected to the water intake pipe in
the oven compartment. Top the
container up with approx. 300ml of
water, as the system will need to
draw in some more liquid during the
activation phase.
The system will take in more liquid at
approximately 5minute intervals. You
will hear the noise of the pump.
The cooling fan remains switched on for
the whole duration of the process.
At the end of the activation phase, a
buzzer will sound.
Rinsing the steam injection system
after the activation phase
After the activation phase the steam
injection system must be rinsed out to
remove residues of descaling solution.
To do this approx. 1litre of fresh tap
water is pumped through the steam
injection system three times and is
collected in the universal tray.
Take the universal tray with the
collected descaling agent out of the
oven and empty it. Place the tray
back in the oven again on the top
shelf level.
Remove the plastic tube from the
container.
Remove the container, rinse it out
thoroughly and fill it with approx.
1litre of fresh tap water.
Replace the container in the oven
compartment and secure the plastic
tube in the container.
Confirm with OK.
The intake process for the first rinse
will start.
The water is fed through the steam
injection system and is collected in the
universal tray.
Instructions for preparing the second
rinse will appear.
Take the universal tray with the
collected rinse water out of the oven
and empty it. Place the tray back in
the oven again on the top shelf level.
Remove the plastic tube from the
container and fill it with approx. 1litre
of fresh tap water.
Replace the container in the oven
compartment and secure the plastic
tube in the container.
Confirm with OK.
Proceed in exactly the same way for
the third rinse.
Leave the universal tray with the
collected rinse water from the third
rinse in the oven compartment during
residual moisture evaporation.
Loading ...
Loading ...
Loading ...