Loading ...
Loading ...
Loading ...
Help Guide
Interchangeable Lens Digital Camera
ILME-FR7 / ILME-FR7K
Setting the Streaming Format
Set the streaming format using [Stream] > [Stream] > [Stream Setting] > [Setting] in the web menu.
When [Setting] is set to [RTSP]
In RTSP streaming, the image from a single camera can be viewed simultaneously by up to five users.
You can set up to two video codec modes.
[Port Number]
Sets the port number to use for RTSP streaming. The default value is 554.
Changing the setting will reboot the RTSP server.
[Time Out]
Specifies the timeout time of the Keep-Alive command for RTSP streaming. The timeout time can be set in the range 0
seconds to 600 seconds. The default value is 60 seconds.
When set to 0 seconds, timeout due to the Keep-Alive command does not occur.
[Authentication]
Sets whether authentication is required.
[Video Port Number 1], [Video Port Number 2]
Specifies the image data communications port number to use for RTSP unicast streaming. The factory default value for
Video Port Number 1 is 51000. The factory default value for Video Port Number 2 is 53000. Specify an even number in
the range 1024 to 65534. The number set here and the subsequent odd number, obtained by adding 1, become the two
port numbers used for image data communications and control.
[Video Port Number 1] and [Video Port Number 2] correspond to [Stream] > [Video Stream] > [Video Stream 1] and
[Video Stream 2].
[Audio Port Number]
Specifies the audio data communications port number used for RTSP unicast streaming. The default value is 57000.
Specify an even number in the range 1024 to 65534. The number set here and the subsequent odd number, obtained by
adding 1, become the two port numbers used for audio data communications and control.
When [Setting] is set to [SRT-Caller] or [SRT-Listener]
The video codec mode is H.264 only.
[Destination]
Displayed when the streaming mode is set to [SRT-Caller]. Sets the connection destination URL.
[Port Number]
Displayed when the streaming mode is set to [SRT-Listener]. Sets the port number on which to listen. The default value
is 4201.
[Latency]
Sets the latency in the range 20 ms to 8000 ms. The default value is 120.
[TTL]
Sets the TTL value in the range 1 to 255. The default value is 64.
[Encryption]
Selects the encryption method. Select Off, AES128, or AES256. The default value is Off.
[Passphrase]
Sets the passphrase used for encryption. Pressing the [Reset] button will reset the configured passphrase.
[ARC]
To enable the Adaptive Rate Control function, set to On.
When the Adaptive Rate Control function is enabled, interruptions in the image caused by communication line
congestion can be reduced.
When [Setting] is set to [NDI|HX]
247
Loading ...
Loading ...
Loading ...