Loading ...
Loading ...
Loading ...
75
Setting the Time Code
3 After completing all the fields of the time code, touch [OK].
• Touch [Cancel] to close the screen without changing the time code.
• If the running mode is set to [ Free Run], the time code will start running from the time code entered
the moment you touch [OK].
4Touch [X].
Selecting Drop Frame or Non-Drop Frame
When the frame rate is set to 59.94P or 29.97P, you can select between a drop frame (DF) or non-drop frame
(NDF) time code, depending on how you plan to use your recordings. When the frame rate is set to 23.98P, the
time code is set to non-drop frame (NDF) and cannot be changed.
1 Select [DF/NDF].
> [3 # Recording Setup] > [DF/NDF]
2 Select [ DF] or [ NDF] and then touch [X].
• The time code display will differ depending on the setting. When you select [ DF], the time code will
appear as [00:00:00.00]; when you select [ NDF], it will appear as [00:00:00:00].
NOTES
NOTES
• When the frame rate is set to 23.98P, the frames value in the time code runs from 0 to 23. For other settings, it
runs from 0 to 29.
• When slow & fast motion recording is activated, you cannot select the [ Free Run] running mode.
Conversely, when pre-recording is activated, [ Free Run] is set automatically and cannot be changed.
• When you mix drop frame and non-drop frame time codes, there might be a discontinuity in the time code at
the point where the recording starts.
• When slow & fast motion recording is activated, the time code signal cannot be output from the SDI OUT
terminal (m only) or HDMI OUT terminal.
• When the camcorder is set to external recording-only mode, the time code mode cannot be set to
[ Regen.].
• When you are using the [ Free Run] running mode, the time code will continue running as long as the
built-in backup battery has some charge left, even if you disconnect all other power sources. However, this is
less accurate than when the camcorder is on.
Loading ...
Loading ...
Loading ...