Loading ...
Loading ...
Loading ...
||
STARTING AND DRIVING
* Option/accessory.
372
Trailer lamp check*
Automatic check
When the trailer has been connected to the vehi-
cle's electrical system, its lamps can be checked
by automatically activating them. This helps the
driver to ensure that the trailer's lamps are func-
tioning correctly before starting to drive.
In order to perform this check, the engine must
not be running.
1. When a trailer is connected to a trailer hitch
or towbar,
Automatic Trailer Lamp Check
will appear in the instrument panel.
2.
Confirm this message by pressing the O but-
ton on the right-side steering wheel keypad.
> The lamp check will begin.
3. Leave the vehicle to perform the trailer lamp
check.
> All of the trailer's lamps will begin to flash
and then each lamp will illuminate one at
a time.
4. Visually check that all of the trailer's lamps
are functioning correctly.
5. After a short time, all of the trailer's lamps
will begin to flash again.
> The lamp check is completed.
Disabling the automatic check
The automatic lamp check function can be disa-
bled in the center display.
1.
Tap
Settings in Top view.
2.
Tap
My Car Lights.
3.
Deselect
Automatic Trailer Lamp Check.
Manual check
If the automatic lamp check has been disabled,
the function can be started manually.
1.
Tap
Settings in Top view.
2.
Tap
My Car Lights.
3.
Select
Manual Trailer Lamp Check.
> The lamp check will begin. Leave the vehi-
cle to perform the trailer lamp check as
described in the section "Automatic
check" above.
Self-leveling suspension*
The self-leveling system attempts to keep the
vehicle at a constant level, regardless of the load
(up to the max. permissible load). When the
engine is not running, the rear of the vehicle
sinks down slightly, which is normal.
Related information
•
Detachable trailer hitch* (p. 372)
•
Trailer Stability Assist (TSA) (p. 373)
•
Weights (p. 529)
Detachable trailer hitch*
Volvo recommends the use of Volvo trailer
hitches that are specially designed for the vehi-
cle.
Ball holder
Cotter pin
Hitch assembly
Locking bolt
Safety wire attachment bracket
Installing the ball holder
1. If necessary, remove the cotter pin from the
locking bolt and slide the locking bolt out of
the hitch assembly.
2. Slide the ball holder into the hitch assembly.
Loading ...
Loading ...
Loading ...