Loading ...
Loading ...
Loading ...
Wheels
WARNING
The use of unsuitable or incorrectly fitted
chains could lead to serious accidents and
damage.
●
Always the appr
opriate snow chains.
●
Observe the fitting instructions provided
by the snow chain manufacturer.
●
Never exceed the maximum permitted
speeds when driving with snow chains.
CAUTION
●
Remove the snow chains to drive on
r
oads without snow. Otherwise they will im-
pair vehicle handling, damage the tyres
and wear out very quickly.
●
Wheel rims may be damaged or scratch-
ed if the chains come into direct contact
with them. SEAT recommends the use of
covered snow chains.
Tyre pressure loss indicator
Contr
ol l
amp
It lights up
The inflation pressure of one or more wheels is much
lower than the value set by the driver, or the tyre has
structural damage.
In addition, a audible warning sounds and a text
message is displayed on the instrument panel
screen.
Stop the vehicle! Stop the vehicle safely as soon
as possible. Check all tyres and pressures. Replace
any damaged tyres.
Flashes
System fault
The control lamp flashes for approximately 1 minute
and then lights up permanently.
If the tyre is inflated correctly, switch the ignition off
and on again. Re-calibrate the tyre pressure loss in-
dicator
›››
page 370. If the fault continues, go to a
specialised workshop.
Several control and warning lamps light up
f
or a f
e
w seconds when the ignition is s
wit
ch-
ed on whil
e the function is v
erified. They will
switch off after a few seconds.
WARNING
Observe the safety warnings
›››
in Con-
trol and warning lamps on page 81.
Tyre monitor system
Fig. 322
Instrument panel: warning of loss of
t
yr
e pr
essur
e
.
The tyre monitor indicator compares wheel
r
e
v
olutions and, with this inf
ormation, the
tr
ead of each wheel using the ABS sensors.
If the r
olling cir
cumference of one or more
wheels has changed, the tyre monitoring indi-
cator will indicate this on the instrument pan-
el through a warning lamp and a warning to
the driver
›››
Fig. 322. When only one specific
tyre is affected, its position within the vehicle
will be indicated.
Loss of pressure: Check left
tyre pressure!
Wheel tread change
The wheel diameter changes when:
●
Tyre pressure is changed manually.
●
Tyre pressure is insufficient.
»
369
Loading ...
Loading ...
Loading ...