Loading ...
Loading ...
Loading ...
Driving
●
The reverse assist has blind spots where
it cannot see people or objects. Monit
or the
vehicle's surrounding area at all times.
●
Keep the camera lens clean, free of ice
and snow, and do not cover it.
●
The system is not a replacement for driv-
er awareness. Supervise the parking ma-
noeuvre and the vehicle's surrounding area
at all times.
●
Do not be distracted from the traffic by
looking at the screen.
●
The images are only two-dimensional.
Protruding objects or holes in the road, for
example, are more difficult to detect or
may not be seen at all.
●
Vehicle load modifies the representation
of the guide lines. The width represented
by the lines decreases with vehicle load.
Pay special attention to the surroundings
when the inside of the vehicle of the lug-
gage compartment are loaded.
●
In the following situations, objects or oth-
er vehicles appear to be further away or
closer than they actually are. Pay special
attention:
–
If moving from a flat surface to a slope
and vice-versa.
–
If the vehicle is heavily loaded.
–
When the vehicle approaches objects
that are not on the ground surface or
that protrude from it. These objects
may be outside the camera angle when
reversing.
Note
●
It is important to take great car
e and pay
special attention if the driver is not familiar
with the system.
●
The reverse assist reference lines disap-
pear when the rear lid is open.
Introduction
Fig. 299
In the rear lid handle: location of the
r
e
v
erse assist camer
a.
A camera installed in the rear lid handle as-
sists the driv
er with r
e
v
erse parking or ma-
noeuvring
›
›
›
Fig. 299.
The camera image is viewed together with
orientation lines projected on the Infotain-
ment system screen. Part of the bumper can
be seen at the bottom, which can be used by
the driver as a reference point.
Reverse assist modes
Depending on the equipment, the following
modes are available:
●
Angle parking: reverse parking perpendic-
ular to the road.
●
Parallel parking: reverse parking parallel
to the road.
●
Assistance function for hitching a trailer:
helps to hitch a trailer.
●
Cross traffic: traffic is monitored in a trans-
verse direction.
Connecting and disconnecting
Connect the reverse assist
●
Select reverse gear.
●
OR: pr
ess button .
Disconnect the r
e
v
erse assist
Driv
e f
orw
ard at least 15 km/h (9 mph).
Shown on the display
The system’s functions and representations
may v
ary depending on the equipment.
The assist
ant's image vie
w changes when the
f
act
ory-fitt
ed t
ow hitch is electronically con-
nected to a trailer
›››
page 339.
328
Loading ...
Loading ...
Loading ...