Loading ...
Loading ...
Loading ...
9100S Dry-Well Calibrator
Safety Information
4
BURN HAZARDS
●●
DO NOT turn the instrument upside down with the inserts in place; the inserts
will fall out.
●●
DO NOT operate near ammable materials.
●●
Use of this instrument at HIGH TEMPERATURES for extended periods of
time requires caution.
●●
DO NOT touch the well access surface of the instrument.
●●
The block vent may be very hot due to the fan blowing across the heater block
of the dry-well.
●●
The temperature of the well access is the same as the actual display
temperature, e.g. if the instrument is set to 375°C and the display reads 375°C,
the well is at 375°C.
●●
For top loading dry-wells, the top sheet metal of the dry-well may exhibit
extreme temperatures for areas close to the well access.
●●
The air over the well can reach temperatures greater that 200°C for high
temperature (400°C and higher) dry-wells. Note: Probes and inserts may
be hot and should only be inserted and removed from the instrument when
the instrument is set at temperatures less than 50°C. Use extreme care when
removing hot inserts.
●●
DO NOT turn off the instrument at temperatures higher than 100°C. This could
create a hazardous situation. Select a set-point less than 100°C and allow the
instrument to cool before turning it off.
●●
The high temperatures present in dry-wells designed for operation at 300°C
and higher may result in res and severe burns if safety precautions are not
observed.
ELECTRICAL SHOCK
●●
DO NOT operate this instrument without a properly grounded, properly
polarized power cord. Electric shock may result.
●●
DO NOT connect this instrument to a non-grounded, non-polarized outlet.
Ensure the earth ground to the outlet is properly connected. Electrical shock
may result if the outlet is not installed correctly.
●●
Always replace the power cord with an approved cord of the correct rating and
type.
●●
HIGH VOLTAGE is used in the operation of this equipment. SEVERE
INJURY or DEATH may result if personnel fail to observe safety precautions.
Before working inside the equipment, turn power off and disconnect power
cord.
●●
If supplied with user accessible fuses, always replace the fuse with one of the
same rating, voltage and type.
1.3.2 Cautions
●●
Always operate this instrument at room temperature between 41°F and 122°F
(5°C to 50°C). Allow sufcient air circulation by leaving at least 6 inches (15
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...